
XPac – “Cost Effective” Riveting Tool
The XPac is an innovative riveting solution, merely attaching to a standard cordless drill, for use on self-piercing rivets, flow form rivets and full punch rivets.

The XPac is a superb new design and innovation from Wielander & Schill, which provides a very “cost effective” solution for self-piercing rivets, flow form rivets and full punch rivets. The XPac is quick to assemble to a standard cordless drill, and enables up to 8 tonnes of riveting pressure.
Benefits of the XPac Riveting System:
-
Mounted Quickly and Easily onto a cordless drill – which acts as the actuator
-
Powerful with up to 8 tonnes of Riveting Pressure
-
Covers self-piercing rivets, flow form rivets and full punch rivets
-
Excellent Low-Cost Introduction to Riveting
-
Provides Extra Riveting Capacity at a Low Price – rather than purchasing an additional XPress 800 riveter
-
Provides Back Up Cover – during periods of servicing/repair of your XPress 800 riveter
-
Approved by Ford and Tesla
Please Note:
A Cordless Drill is required with a specification of a minimum torque of 12.5Nm and a speed of 1250 – 1500rpm (Drill not supplied with the XPac)

Testimonials
MG Cannon partner with Bodyshop Solutions for equipment sourcing, because we value their wide range of product expertise, our manufacturer partner programme knowledge and the professional advice we receive when choosing each purchase. Aftersales care, response to any questions and servicing needs is always timely, to a quality standard and results are reported back. I would strongly recommend them.