Wielander & Schill Foot Switch – I-Ductor Heat Inductor Accessory (842113)

Wielander & Schill Foot Switch – Hands-Free Control for the I-Ductor

The 842113 foot switch gives you hands-free on/off control of your Wielander & Schill I-Ductor heat inductor. Instead of reaching for the unit’s controls, you simply press the foot pedal to start heating and release it to stop. As a result, both hands stay on the coil and the workpiece at all times.

Why Add a Foot Switch to Your I-Ductor?

When you use the I-Ductor for bolt heating, paint removal, or panel work, precise coil placement is essential. However, if one hand has to leave the coil to operate the power switch, you risk losing position — and therefore wasting time repositioning before the next heat cycle.

The foot switch solves this problem completely. Because you activate the inductor with your foot, both hands remain free to hold and guide the coil exactly where it needs to be. Consequently, you get faster cycle times, more consistent heat application, and better overall results.

In addition, the foot switch improves safety. For example, if the coil slips or you need to stop heating immediately, a quick lift of your foot cuts the power instantly. This is much faster than reaching for a hand-held switch, especially when you are working in awkward positions under a vehicle.

Key Benefits

• Hands-free operation: Both hands stay on the coil, so you maintain precise positioning throughout the heat cycle
• Instant on/off control: Press to activate, release to stop — there is no delay and no fumbling for switches
• Improved safety: You can cut power immediately by lifting your foot, which is faster than reaching for a hand switch
• Better heat accuracy: Because you hold the coil steady with both hands, heat application is more consistent and controlled
• Faster workflow: Eliminating the need to reposition after each activation saves valuable time across multiple jobs
• Simple connection: The foot switch plugs directly into the I-Ductor unit, so setup takes just seconds

Compatibility

This foot switch works exclusively with the Wielander & Schill I-Ductor heat inductor. It plugs directly into the unit and requires no additional wiring or configuration. If you already own an I-Ductor, then adding the foot switch is a straightforward upgrade that you can start using immediately.

Technical Details

Ideal Use Cases

The I-Ductor foot switch is particularly valuable when you are working in situations that demand both hands on the coil. For instance, these include:

• Loosening seized bolts in tight underbody spaces where coil placement is critical
• Removing adhesive-bonded trim, badges, and mouldings that require steady, even heat
• Heating panel sections for paintless dent repair or straightening work
• Softening paint and underseal for removal without damaging the substrate
• Any task where the operator needs to reposition the coil frequently between short heat bursts

Furthermore, workshops that use the I-Ductor across multiple technicians often find that the foot switch becomes standard practice. Once technicians experience hands-free control, they rarely go back to manual switching.

Expand Your I-Ductor Accessory Range

Wielander & Schill offer several interchangeable coils and accessories for the I-Ductor system, including the bolt heater (842119) and various induction coil shapes. By combining the foot switch with additional coils, you maximise the versatility and efficiency of your I-Ductor investment.

For pricing, availability, and expert advice on the full range, call Bodyshop Solutions on 01327 300700.